2026-10-23T16:34:18

Iron Fence Installation Cost per Meter 2026: Hollow, Welding and Paint

Iron fence installation cost per meter as we read it on 23 October 2026 is very wide: Talentama lists three packages at Rp350,000, Rp500,000 and Rp700,000 per running metre (4×4 cm galvanized hollow, 1.2-1.6 mm), Appasco Rp600,000-Rp950,000 per metre installed for minimalist hollow, and Terasly Rp1,200,000-Rp2,500,000 per running metre for a 1.5-2 m galvanized hollow fence. So the hollow steel fence price per meter differs roughly sevenfold between the lowest and highest figures in the table, because the scope counted is not the same. A steel fence installation service Indonesia labour-only rate is written as Rp150,000-Rp250,000 per metre by Talentama and Rp400,000-Rp800,000 per m² by Jasatukang. These figures come from vendor blogs, not a quote for your house.

Iron fence installation cost per meter 2026: source comparison

Scheme or component	Spec per the source	Price	Scope note	Source
Talentama: economy tier	Galvanized hollow 4×4 cm, 1.2 mm, plain	Rp350,000 per running metre	Source breakdown: material 140 thousand, labour 90 thousand, finishing 80 thousand, accessories 40 thousand	Talentama
Talentama: standard tier	Hollow 1.4 mm with epoxy finish	Rp500,000 per running metre	Material 200 thousand, labour 110 thousand, finishing 120 thousand, accessories 70 thousand	Talentama
Talentama: premium tier	Hollow 1.6 mm, pattern and full powder coating	Rp700,000 per running metre	Material 280 thousand, labour 130 thousand, finishing 180 thousand, accessories 110 thousand	Talentama
Talentama: installation labour only	Standard width 2-2.5 m	Rp150,000-Rp250,000 per metre	This is higher than the labour component in the three tiers (90-130 thousand) on the same page; the source does not explain the difference	Talentama
Appasco: minimalist hollow steel	Not detailed	Rp600,000-Rp950,000 per metre (installed)	Article dated 20 Feb 2026; gate and extra finishing written as roughly 1.5-3 million for a 10 m fence example	Appasco
Terasly: galvanized hollow fence	Height 1.5-2 m; low end: plain 2 mm hollow; high end: 4 mm hollow, carving, powder coating	Rp1,200,000-Rp2,500,000 per running metre	Includes primer and standard finish; stainless 304 can be 2-3 times higher; article labelled 2026	Terasly
Jasatukang: iron fence labour rate	Iron fence; concrete fence Rp500 thousand-1.2 million/m²; wooden fence Rp350-700 thousand/m²	Rp400,000-Rp800,000 per m²	Labour only, per m² of fence face (length × height), not per running metre	Jasatukang
Galaxy 2 Bangunan: galvanized hollow 4×4 × 1.2 mm	Written 1.2 (1.05); bar length not written	Rp142,000 per bar	Surabaya shop price, 23 Oct 2026	Galaxy 2 Bangunan
Galaxy 2 Bangunan: galvanized hollow 2×4 × 1.2 mm	Written 1.2 (1.05); bar length not written	Rp110,000 per bar	Surabaya shop price, 23 Oct 2026	Galaxy 2 Bangunan
Mitra10: Propan Metalkote AP-291 SB 1 kg (anti-rust steel paint)	Anti-rust base coat; coverage not read by us	Rp43.600	Price per pack, 23 Oct 2026	Mitra10
Mitra10: Jotun New Gardex Primer 0.9 L white	Steel primer	Rp83.400	Price per pack, 23 Oct 2026	Mitra10
Mitra10: Top Color Duco Besi Solid 222-2833 matt black 1 L	Duco steel paint; coverage not read by us	Rp85.800	Price per pack, 23 Oct 2026	Mitra10
Mitra10: Ftalit Duo steel paint 135-531 white 0.9 L	Oil-based steel paint	Rp66.600	Price per pack, 23 Oct 2026	Mitra10

Accessed 23 October 2026. The labour sources are vendor or contractor blogs: Talentama (page dated 03/05/2026), Appasco (20 February 2026), Terasly and Jasatukang (no publication date read by us); hollow prices from Galaxy 2 Bangunan and paint from Mitra10 (final displayed price). Per-running-metre and per-m² figures are not equivalent; we did not convert them. Data gaps: no official welder rate data; Talentama, Appasco and Terasly contradict each other and do not detail fence height, posts, foundation or gate; Depo Bangunan and Mitra10 sold no hollow section in our search; paint coverage not read.

Hollow material simulation per running metre (homeX calculation)

homeX assumptions, not data: fence 1.5 m high, post spacing 2.5 m (1 post of 4×4 hollow 2.0 m long including the buried part per 2.5 m), top and bottom rails of 4×4 totalling 5.0 m, 17 vertical 2×4 infill bars of 1.4 m per 2.5 m, 1.2 mm galvanized hollow, 6 m bars (bar length is not written in the Galaxy 2 table). At Rp142,000 per 4×4 bar and Rp110,000 per 2×4 bar, frame and infill material comes to about Rp240,800 per running metre without waste, or about Rp264,880 with 10% waste. This excludes paint, welding, accessories, post foundations and labour. The Talentama page states a need of 8-12 bars of 4×4 per running metre, far above this calculation (about 2.1 bars per running metre across all sections); we did not use that figure.

Budget example for a 10 running-metre fence (homeX calculation from source figures)

With the three Talentama tiers, 10 running metres comes to Rp3,500,000, Rp5,000,000 and Rp7,000,000. The Appasco example uses Rp800,000 per metre, i.e. Rp8,000,000, plus a gate and finishing of about Rp1,500,000-Rp3,000,000 (as written by the source). At the Terasly low and high ends, 10 running metres comes to Rp12,000,000-Rp25,000,000. The largest gap reflects different scope (height, hollow thickness, pattern, finish), not a quality measure.

Ask for a written quote you can compare

Terasly advises that a written quote state the material type and thickness in mm, the finish type and number of coats, estimated working time, a minimum 6-12 month warranty, and what the installation fee includes, including supporting materials such as bolts, hinges and rails. Terasly also warns about quotes far below the range with no explanation and very large down-payment requests. For fences that carry load, such as a heavy sliding gate, ask for an engineering calculation.

Buyer tips

Compare quotes with the same scope: height, hollow thickness, finish, posts, foundation, gate.
Ask whether the price is per running metre or per m².
Ask for an anti-rust primer before the finish coat; see our steel paint article.
Do not use blog figures as final prices; ask for a survey and a written quote.

Request a iron fence installation cost per meter quote for your project

homeX can compare several brands at once and prepare a written quote for projects, renovations or shop stock. Send your needs (brand, size, quantity, location) via WhatsApp +62 821 1818 998, or visit the homeX showroom: Priskilla Tower, 6th floor, Jl. Atang Sanjaya No.21, Benda, Kota Tangerang, Banten 15125. Visit the homeX Showroom.

Disclaimer: prices change without notice and differ by store, city, pack size, grade and promotion. Data as of 23 October 2026; always confirm with the seller before buying.

FAQ

How much does iron fence installation cost per meter? Per public sources on 23 Oct 2026: Talentama Rp350,000-Rp700,000 per running metre (three tiers), Appasco Rp600,000-Rp950,000 per metre installed, Terasly Rp1,200,000-Rp2,500,000 per running metre. The scope differs by source.

What is the labour-only rate for a steel fence? Talentama Rp150,000-Rp250,000 per metre; Jasatukang Rp400,000-Rp800,000 per m². The units differ, so they cannot be compared directly.

Do Mitra10 or Depo sell hollow steel? In our search on 23 Oct 2026 neither had hollow sections; the hollow prices in this article are from Galaxy 2 Bangunan (Surabaya). Mitra10 sells steel paint, which is in the table.